專業5MBM22S(P) - Mirror Mount廠商

		1" and 2" optics mounts
		Precise (sensitivity of 3 arcsec and 1µm)
		Stable, with hard (steel/sapphire) seats under driving screws
		Tilt range of 5° in two orthogonal planes
		Travel range 4 mm
		Original stabilized L-shaped flat spring
		Vertical mounting on either of two sides
		"Mirror" versions available
		Made of black anodized aluminium

Mounts 5MBM22S, 5MBM22SP have a 1” and 2” mounting hole. A fixing screw secures the optics against 2 contact lines, which make 2 contact points. To prevent damage to the optics, the tip of the fixing screw is made of plastic. On one side the edge of the optics stays clear. So you can use the optics close to the edge in schemes where beams are very closely situated to one another. You may order mounts with 2 and 3 driving screws. Each screw has a hardened steel ball tip. It pushes the aluminium platform against a hard seat. This results in increased durability, stability, and fine motion. M6/Ø7 mounting/clearance holes are centered against the center of the mounted optics. The platform has an original L-shaped flat spring. It performs two functions: preloading the platform, and reducing its drift. The high-tension spring and the thick base of the unit increase its stability. This allowed to eliminate a part of the mount, keeping clear one side of the optics. Material: aluminium. Finish: black anodized (by default), or any other color on request.

A screw pushes via a seat of hardened stainless steel or sapphire. Both models use Fine screws 9S127 (with knobs) or 9SH127 (without knobs, hex key included) risk of tempering is reduced.

Rigid flat spring ensures stability and makes 5MBM22 series set-and-forget type of mounts.

           Flat spring (side view)